how to make an electrolosis unit?

[PAmike]

I have an older 6/12 volt battery charger that I found in a car I bought a few years back. It work ok I guess but has no clamps so I can't charge batteries so I just found a use.

Could someone please tell me how I can use my battery charger to make an electrolosis unit. I am sure there are a few others that could put this onfo to good use as well.

mike

[jeff of pa]

didn't you see the link I gave you ?

[jeff of pa]

go to "BATTERY CHARGER ? "

[PAmike]

Works great. Thanks jeff.

mike

[DiggerDude101]

Cut the lead of the end. Split the two wires back about 2 - inches. Strip the ends of the wires and install an alligator clip on each end.

Then place the positvie end on the coin the other on a silver spoon place both into water with about a tablespoon of salt.
(the coin should start bubbling. If the spoon bubbles. cahnge the clips around.) with a 12 v charger it you should see some results in about an hour.


Good luck.