port ewen ace
Silver Member
- Dec 16, 2012
- 4,065
- 7,786
- 🏆 Honorable Mentions:
- 2
- Detector(s) used
- AT-PRO & Equinox800
- Primary Interest:
- All Treasure Hunting
error-ref. says this is usually caused by excess heat after minting. large raised bubbles from internal gases on both sides. hope this is a lam defect. will show it to my LCS today and contact MDia1 for his opinion. a little Pro-active & Jack will maybe heal
surface color is not normal but no evidence of direct heat, maybe intense fire heat
Upvote
0