Gray ghost amphibian Head phones installation on CTX

Sandscoopdan

Sr. Member
May 19, 2012
327
133
Cypress,Tx
Detector(s) used
Minelab Excalibur II
Minelab CTX 3030
Minelab Equinox 800
Extreme scoop
Boat: 20ft Four Winns w/92 V8 5.0L Cobra Mustang engine
Primary Interest:
Beach & Shallow Water Hunting
I noticed there is no oring on the connector of the phones. Does anyone have experience installing the Amphibians on a CTX? I am not sure if I need to put an oring on the outer part of the connect or just tighten the head phone connector in and hope water doesn’t enter into the water head phone connector and I notice the headphone connector does not thread in all the way. I am going to head out in a few hours to the beach and was really looking forward to trying out these new phones but cannot find any answers on proper installation anywhere online.
Thank you,
Dan
 

Treasure_Hunter

Administrator
Staff member
Jul 27, 2006
48,433
54,820
Florida
Detector(s) used
Minelab_Equinox_ 800 Minelab_CTX-3030 Minelab_Excal_1000 Minelab_Sovereign_GT Minelab_Safari Minelab_ETrac Whites_Beach_Hunter_ID Fisher_1235_X
Primary Interest:
All Treasure Hunting
Oring should be on the inside of the connector on the 3030.
 

OP
OP
Sandscoopdan

Sandscoopdan

Sr. Member
May 19, 2012
327
133
Cypress,Tx
Detector(s) used
Minelab Excalibur II
Minelab CTX 3030
Minelab Equinox 800
Extreme scoop
Boat: 20ft Four Winns w/92 V8 5.0L Cobra Mustang engine
Primary Interest:
Beach & Shallow Water Hunting
Ok thank you
 

Top Member Reactions

Users who are viewing this thread

Top