Excalibur 2 help?

Aussie

Sr. Member
Nov 2, 2009
302
249

Treasure_Hunter

Administrator
Staff member
Jul 27, 2006
48,305
54,462
Florida
Detector(s) used
Minelab_Equinox_ 800 Minelab_CTX-3030 Minelab_Excal_1000 Minelab_Sovereign_GT Minelab_Safari Minelab_ETrac Whites_Beach_Hunter_ID Fisher_1235_X
Primary Interest:
All Treasure Hunting
Sounds like stem fail out of lower shaft. Use a good marine grade water proof glue to put it back on, be sure it is aligned properly. I did mine by aligning it perfectly and marking stem and lower shaft so when I glued it just had to align the marks.
 

Treasure_Hunter

Administrator
Staff member
Jul 27, 2006
48,305
54,462
Florida
Detector(s) used
Minelab_Equinox_ 800 Minelab_CTX-3030 Minelab_Excal_1000 Minelab_Sovereign_GT Minelab_Safari Minelab_ETrac Whites_Beach_Hunter_ID Fisher_1235_X
Primary Interest:
All Treasure Hunting
Thankyou will see what I can find.
Appreciated

I used a 2 part marine epoxy, just be sure you line it up perfectly then scratch a line on both pieces so you can aligned it perfectly when you glue it, once the glue sets up you will not be able to adjust it.
 

Nov 12, 2019
14
9
Ft. Laud., FL
Detector(s) used
CURRENT: MINELAB EQUINOX 800 WITH ALL COILS. GARRETT SEA HUNTER II.

PREVIOUS: WHITES V3i; MINELAB EXPLORER II, MINELAB SD2100; JW FISHERS 8X; MINELAB EXCALIBUR 1000
Primary Interest:
Beach & Shallow Water Hunting

Top Member Reactions

Users who are viewing this thread

Top