AT Pro going bananas

[bigjerryok]

My Pro is going bananas every time I switch it on. I've separated the control unit from the coil, and it still beeps uncontrollably. I managed to take it apart, and dried the insides with a hair dryer - on old Pros like mine, moisture can get in - but to no avail. Don't know what to try next - any suggestions? Hope video below posts, and thanks in advance for any help.

https://www.facebook.com/search/top/...erry%20gardner

[mindcrime1988]

Have you tried a factory reset?

[bigjerryok]

Yup. No dice, sadly, mindcrime.

[bologna321]

I know you have but, new batteries? How about changing the frequency?

[mindcrime1988]

Yup. No dice, sadly, mindcrime.

After checking all of the basics and you are still having issues, I would contact Garrett. They have one of the best customer service reputations out there.

[A2coins]

No small piece of iron in bedded in your coil I sent my pro to garrett twice 2 years after warranty fixed free both times new box They also shipped very quickly

[CoinFetcher]

Arg ——- sensitivity low?? Try a new local.....

[A2coins]

Also if you get a bad ground balance your numbers will just run all wacko GB in a clean area if your are in an area with a lot of iron it will be hard to get the balance . Try also by setting manually to what it usually is see if that helps

[A2coins]

call garrett also tech guys are great plus they will probably send you a free coil check connections and pins also

[caretaker]

mine did the same, it started last Nov, just sent it in last Thursday and they called and said it was all done, about a week an a half turn around , couldn't ask for anything better, give them a call and they will give you a # to put on the package, mine need a new coil too

[NWMP]

Peal the coil cover off and give it and coil a good cleaning. Sometimes they pack up with crud and the machine gets erratic.