AT Pro

[Gunrunner61]

Has anyone else run into this problem ? Or am I doing something wrong?

[gleaner1]

Them danged enjineers didnt have theyer thinkin caps on dat day.

[DIRTDOCTOR]

Loosen camlock - release and move upper shaft out 2 notches. THANKS DIRTDOCTOR

[Gunrunner61]

Best not to mess with camlocks. Just take a phillips screwdriver and loosen two screws on bottom that connects housing to the shaft. Install new batteries same way the old ones were removed - turn detector on to make sure..even a screwloose like me did it wrong one time. Tighten screws. I usually replace my batteries when the bar just hits one and don't wait until the detector starts acting up.

So you have the same problem huh?

[Thunderchild]

I had the exact same issue. Diertdoctor is correct about extending out a couple notches. Worked on mine. You don't want to hassle with carrying a screw driver around and them having to unscrew the dang housing from the shaft each time to change batteries. Love the AT PRO!

[vanner1]

Just adjust that camlock down out of the way a bit... and if needed extend from the bottom. No problems with battery changing after that

[Bearkat]

It's in one of Garrett's video and or manual on proper methed in putting together the AT to avoid this. Check out your manual or look at Garrett's videos on their website...