Bought Coinmaster 6000Di from Ebay/ toggle switch broken..be fixed ?

[Jaw Jah Danny]

Guess I'd better send to White's to fix it, me being a newbie. Put battery pack in and it's buzzing. Can't check it out till toggle switch fixed. Guess the toggle is for air/ground balance. Will have to down load instructions later. Paid 150 bucks for it. Has 2 coils. I like the older MD'er. Guess cause I'm old

Please give me feedback. If you do not want to embaress me, send PM. If you don't care if you embaress me in public..go ahead . Hell..I'm not thin skinned

thanks forum ladies and gents............

[Ads]

TreasureNet.com is the premier Treasure Hunting Forum on the internet. Registered Users do not see these ads. Please Register - It's Free!

[Saturna]

A Miniature toggle switch of some kind.
You would have to do a little disassembly to determine if it's single pole/single throw(SPST), double pole/double throw(DPDT), etc. Basically this means the number of tabs on the bottom.
Or does it have a center position, also? There are many variations.

There may be a number on the side of the switch. Is it soldered into the circuit board?
White's may have replacements, but I suspect it will a standard item, not a White's specific part.



Example website...

http://www.electronicplus.com/conten...=SW&subcat=SMI



Jay

[Shortstack]

JJD, if you can solder, you can make the repair yourself. Open the control box enough to get access to the toggle switch so you can see how many contacts it has. I would guess it has 3; one input (center contact) and 2 outputs. There should be enough slack in the wires to allow you to snip the wires from the switch leaving just enough insulation on the switch to be able to match the wires back to the correct post. You should be able to match the switch at any Radio Shack. That mini toggle with the correct number of posts is fairly common. From the look of the printing on the box, it appears to be a double-pole / double throw switch. If it is soldered directly on the circuit board, don't try to replace it yourself if you don't know what you're doing. The heat can fry a nearby component on the board.

If you can't do this yourself, ask around and find a Ham Radio person. He or she could handle the replacement with no problems. If you send the detector back to Whites, they'll charge you for the work and parts. Call them and ask what their total charges would be so that you can make a good decision. Tesoro is the only manufacturer with life time warranties. Good luck.

[mlayers]

I hope they told you on ebay that it was broken. Hope you can fix it yourself so it don't cost you to much....Matt

[curbdiggercarl57]

I'd send it to Whites, just to make sure. Never had a problem with them, great people. Might want to call them first, let them know what's up.
Carl

[Jaw Jah Danny]

thanks guys

[warsawdaddy]

Anything can be fixed.Heck,I didn't even know my dog was broke but they said they fixed her!

[DANGLANGLEY]

Anything can be fixed.Heck,I didn't even know my dog was broke but they said they fixed her!

That was sooooo good!

DANGLANGLEY

[liftloop]

Oor the'll fix eny thing but a broken hart!