woodtick
Tenderfoot
- Oct 12, 2012
- 6
- 23
- Detector(s) used
- AT PRO, BH Discovery 3300
- Primary Interest:
- All Treasure Hunting
Hi All,
I've been using this machine for a few outings - new to the hobby. While I have found 3 clad coins in 3 outings, I'm getting a ton of signals and trash. I set the discrimination up and I'll think I have a dime and it's an aluminum can. It'll read a penny and I'll dig up scrap iron trash from a can. I've attempted to ground balance but not sure if I've done it correctly. I'll also pinpoint it, dig, find nothing, scan again and it's either a few inches from the hole or the signal is gone entirely. Getting frustrated.
What experience have you guys had with this unit? What are the challenges in using this rig? Is it a good machine or just so/so? I'm trying to figure out if it is me, the machine or both.
Thanks.
I've been using this machine for a few outings - new to the hobby. While I have found 3 clad coins in 3 outings, I'm getting a ton of signals and trash. I set the discrimination up and I'll think I have a dime and it's an aluminum can. It'll read a penny and I'll dig up scrap iron trash from a can. I've attempted to ground balance but not sure if I've done it correctly. I'll also pinpoint it, dig, find nothing, scan again and it's either a few inches from the hole or the signal is gone entirely. Getting frustrated.
What experience have you guys had with this unit? What are the challenges in using this rig? Is it a good machine or just so/so? I'm trying to figure out if it is me, the machine or both.
Thanks.
