Testing is DONE... now heres the gold.

[goldhog]

Testing is DONE... now here's the gold.

Seems like months... but really its been weeks.
Testing and testing and testing.
Finding the good spots and the gold lines.
Then figuring out the best matting config for this homemade beast...

We're on a decent gold line that should last as long as we can run, before winter pushes us out.
At least by that time we'll be focused on our mine / op in Honduras.

Running bare mats.
Dual engines at 100% screaming water over them with the 5".
Running all RiverHog with riffles cut lower and lower as it goes down the sluice.
Upper portion has 1/4" punch plate for about 20" with VERY low Riverhog under it.

This is about an hour test run.

All the pics are the same pan.
Real happy we can just run now and stop "thinking" so much.

Tapped into the corner...


Spread out some...


Spread out more...

 

Amazon Forum Fav 👍

DR.ÖTEK Metal Detector, Waterproof Gold Detector, Pinpoint & Terrain Modes, Professional Metal Detector - Grab it through Amazon!

[loco oro]

very impressive for an hour,i stumbled on one of your vids befor joining the forum and i have been impressed, it is nice to just run after long dilgent work, your results are proof that it is what needs done, very impressed!

 

[Sample Pan Dan]

I like your sluice mats more and more, everyday.

 

[Jason in Enid]

What angle of drop are you using for your box while running like that?

 

[goldhog]

What angle of drop are you using for your box while running like that?

it is on our 5" dredge... we can't really get too much pitch.
We have moved our motors to the vary back.
We have moved our air system to the very back.
We have even put two LARGE rocks on the back to get more.
I will have to measure it, but I'm sure it's at least 8%.
I'll try and get the measurement while it's running.
Doc

 

[russau]

yep,id be very happy with that amt og gold mysef for that legnth of time! very impressive!

 

[AzViper]

Seems like months... but really its been weeks.
Testing and testing and testing.
Finding the good spots and the gold lines.
Then figuring out the best matting config for this homemade beast...

We're on a decent gold line that should last as long as we can run, before winter pushes us out.
At least by that time we'll be focused on our mine / op in Honduras.

Running bare mats.
Dual engines at 100% screaming water over them with the 5".
Running all RiverHog with riffles cut lower and lower as it goes down the sluice.
Upper portion has 1/4" punch plate for about 20" with VERY low Riverhog under it.

This is about an hour test run.

All the pics are the same pan.
Real happy we can just run now and stop "thinking" so much.

Tapped into the corner...
View attachment 864181

Spread out some...
View attachment 864182

Spread out more...
View attachment 864183

Can we see photos of the the sluice box and punch plate?

 

[goldhog]

Can we see photos of the the sluice box and punch plate?

It's the same as in the last video of the dredge, but we put new mat in to handle the BIG, deep, FAST flow.
It's all RiverHog now, but we cut it down as you get further down the sluice.
We also cut the main riffle alternating the cut angle every other mat. Like: / then \ then / etc.
One gives a soft rolling vortex, the other a sharp cutting strong one.
We are running the engines at 100%, more pitch, and really screaming the water.
Keep in mind we don't have a flare on this unit, so the design is strange on the top.
Doc