Big Item Question

[gods country girl]

i have detecting in relic mode, and i have found some misc hunks of metal and nails yet to be cleaned up and identified.my question is i keep getting a big item signal and i have dug 12" down and its still showing big item how far should i go?

 

Amazon Forum Fav 👍

How to Research for Treasure Hunting and Metal Detecting From Lead Generation to Vetting - Grab it through Amazon!

[jeff of pa]

stop at 125 Feet

You don't wanna hit water

Seriously Though, I quit when I Decide I Dug far enough

I Know that Nickel signal is here yet

 

[savant365]

Try probing out instead of deeper, I dug about 2 feet down right thru the center of an old metal barrel strap that was only about 4 inches deep. Wasted a couple of hours trying to find my target lol. good luck,

HH Charlie

 

[gods country girl]

ty will try the probe

 

[savant365]

Let us know how it goes

HH charlie

 

[Iron Patch]

Your decision depends on what type of site your on. For me, I dig until I get to the target which is usally not much more than two feet, and seldom in the range of 3 feet, but if it's deeper I keep going.

 

[DigginThePast]

stop at 125 Feet

You don't wanna hit water

Seriously Though, I quit when I Decide I Dug far enough

I Know that Nickel signal is here yet

I bet its one of those pesky little silver 3 centers

 

[lumbercamp]

Could be a safe full of money from the Austin flood. Keep digging til you find it, and keep quiet when you suddenly become rich!!

 

[gods country girl]

went 18" down still said big item.from the display, it shows whatever it is ,is about 2 foot across.i covered it back up loosely, i think i will try to dig it some more on my next days off.