ScubaDetector
Silver Member
I put this under the heading the Tool Shed before I found this heading. Probably in the wrong spot.
I have a wonderful backup and secondary machine in the Tiger Shark. After I clear weeds and hunt with the CZ-21, I go back over a lot of the places with the Shark. I don't think it gets deeper than the CZ-21. However, I do know it gets things the CZ-21 misses and it for sure has it's own place in my detector arsenal.
However, I was really hating the S rod. It was so hard to push down into weeds and move around it frustrated me. I had an extra rod for a Fisher 1280X that died and I thought a few holes drilled, the shaft shortened and presto. I would have a new diving machine.
So tonight I got out my drill press, cut off saw and screwdrivers and went to work. Since I never wade with the TS, I cut the lower rod down also. I took the clips out of the middle rod to mount the box on the Fisher upper rod. Hopefully this setup will work for me as it certainly does with the CZ's I have.
I have a wonderful backup and secondary machine in the Tiger Shark. After I clear weeds and hunt with the CZ-21, I go back over a lot of the places with the Shark. I don't think it gets deeper than the CZ-21. However, I do know it gets things the CZ-21 misses and it for sure has it's own place in my detector arsenal.
However, I was really hating the S rod. It was so hard to push down into weeds and move around it frustrated me. I had an extra rod for a Fisher 1280X that died and I thought a few holes drilled, the shaft shortened and presto. I would have a new diving machine.
So tonight I got out my drill press, cut off saw and screwdrivers and went to work. Since I never wade with the TS, I cut the lower rod down also. I took the clips out of the middle rod to mount the box on the Fisher upper rod. Hopefully this setup will work for me as it certainly does with the CZ's I have.
