Coil cable outer jacket issue

MrNelson

Jr. Member
May 2, 2012
64
10
Fernandina Beach, FL
Detector(s) used
Minelab Sovereign Elite
Primary Interest:
Beach & Shallow Water Hunting
Hey fellow hunters! I just pulled my sov elite outta storage and get back into hunting the First Coast again. I ran into a little snag... the coil cable outer jacket is falling off in small pieces, as if its rotting/dried out. The individual cables inside are in solid and intact. Would I be good by just wrapping it with some electrical tape just to get by? If the cable is a replaceable unit i can buy one later. My machine is stock with stock 10" coil. Thanks for all the advice in advance.
 

cudamark

Gold Member
Top Banner Poster
Mar 16, 2011
13,223
14,546
San Diego
🥇 Banner finds
1
🏆 Honorable Mentions:
3
Detector(s) used
XP Deus 2, Equinox 800/900, Fisher Impulse AQ, E-Trac, 3 Excal 1000's, White's TM808, VibraProbe, 15" NEL Attack, Mi6, Steath 920ix and 720i scoops, TRX, etc....
Primary Interest:
All Treasure Hunting
I think I'd rather dip them in plastic.....the stuff you use on tool handles. Electrical tape can get gummy and sticky after a while. Especially if it sits in a hot car for any length of time.
 

Top Member Reactions

Users who are viewing this thread

Top