Headphones For Minelab CTX3030

[tabman]

Will my Killer B Wasp Headphones work on a CTX3030? Will I need an adaptor? Also will the new wireless Minelab Headphones work on the older CTX3030 detectors.

tabman

 

Amazon Forum Fav 👍

DR.ÖTEK Metal Detector, Waterproof Gold Detector, Pinpoint & Terrain Modes, Professional Metal Detector - Grab it through Amazon!

[DeepseekerADS]

My Killer B headphones DID NOT work with my CTX. Don't know about the Wasp.

 

[Treasure_Hunter]

Headphone jack must be stereo, mono jacks will not work. the voice module is 1/4 inch jack so need 1/4 inch stereo headphones. If your talking about the waterproof headphones then you will need to have a 3030 connector put on. The stock headphones and stock voice module is NOT waterproof.

 

[PowerDubs]

I use the killer bee stinger – single-sided headphone – on my 3030, with the wireless module.

It works fine that way, but the volume is not very loud.


Sent from my iPhone using Tapatalk

 

[Jeff In North Georgia]

Will my Killer B Wasp Headphones work on a CTX3030? Will I need an adaptor? Also will the new wireless Minelab Headphones work on the older CTX3030 detectors.

tabman

Minelab published info on this:
http://www.minelab.com/__files/f/93182/CTX-3030-Audio-Options-KBA_21-2.pdf

Look at CTX 3030 Audio Options

Jeff

 

[Metal Detecting Stuff]

As Jeff's info shows, you either need a mono to stereo adaptor, or need to plug directly into the WM 10 wireless module. Sunray Pro Gold for CTX also has a special button to do the conversion.

Wayne

www.metaldetectingstuff.com

 

[tabman]

Thanks Everyone! One last question, do all CTX-3030 detectors work with the WM 10 Wireless Audio Module, even the older ones?

tabman

 

[FschJg]

Thanks Everyone! One last question, do all CTX-3030 detectors work with the WM 10 Wireless Audio Module, even the older ones?

tabman

Yes!

 

[Repo Archaeologist]

Has anyone used the Garrett Z-Link wireless set up on the CTX 3030? I tried it on mine and it did connect up and seemed to work doing air test.

 

[Jason in Enid]

Has anyone used the Garrett Z-Link wireless set up on the CTX 3030? I tried it on mine and it did connect up and seemed to work doing air test.

Why the hell would you use the Z-link when Minelab already has the WM-10 system that it comes with. The Wm-10 has less lag time than the z-link too.

BTW - the z-link is proprietary and wont conntect to any other sender/receiver. Same with the WM system.