hole in pin pointer

RichieSoprano

Jr. Member
Jun 3, 2019
37
42
Maine, formerly NJ
Detector(s) used
Teknetics Patriot Bedliner on DD Coil
Primary Interest:
Metal Detecting
Clean well with Q- tip dipped in acetone. Mix 2 part NON-METALLIC epoxy and cover hole provided it is small. Then smear epoxy around the tip and cover with a plastic thread protector. Should buy you quite some time. You can always replace the thread protector from time to time by shaving off only the flat end as it too will eventually wear out. But hey, beats another hundred bucks, right?
 

Top Member Reactions

Users who are viewing this thread

Latest Discussions

Top