Map of East Florida Coast w/ Lease Areas??

ScubaFinder

Bronze Member
Jul 11, 2006
2,220
528
Tampa, FL
Detector(s) used
AquaPulse AQ1B - AquaPulse DX-200 Magnetometer
Primary Interest:
Shipwrecks
Does a map of the East coast of Florida exist that already has the currently held lease areas marked on it? I tried to punch the GPS coordinates of the Fisher leases into Google Earth but it seems to be quite a bit off. Some of the lease areas show to be centered over intercoastal waters or over land. I'm thinking this can't be right...can it? If it's not right, does anyone have a map that shows the areas (not looking for exact coords, just a general idea of what areas are leased and which parts are not.

Thanks,

Jason
 

deepsix47

Hero Member
Jul 26, 2006
644
17
Detector(s) used
Fisher Impulse, Fisher CZ-21, Minelab X-Terra 70
Primary Interest:
All Treasure Hunting
ScubaSeeker said:
Does a map of the East coast of Florida exist that already has the currently held lease areas marked on it? I tried to punch the GPS coordinates of the Fisher leases into Google Earth but it seems to be quite a bit off. Some of the lease areas show to be centered over intercoastal waters or over land. I'm thinking this can't be right...can it? If it's not right, does anyone have a map that shows the areas (not looking for exact coords, just a general area of what areas are leased and which parts are not.

Thanks,

Jason

There is (or was) a pamphlet available in the 90's that showed the locations of the Fisher leases along the Treasure Coast. I believe it could be obtained from Mel's Museum in Sebastian. I don't remember any of them extending into the intercoastal but some did go up onto the beaches. Since the beaches are not private here in Florida, the mean low water mark had to be used as a defining line. When a "pinpoint" lease is obtained, the dimensions of that lease are set from a center point, many times over the main ballast pile. As the ballast piles are located on the reefs close to shore, some of the lines could extend onto the beach.

Also, once a lease has been obtained it is a matter of public record and you can get the info in Tallahassee. It is worthy of note that with winter approaching we will be getting some heavy minus tides. Watch the tide tables, you will be able to get further out and into areas not normally available to be worked.

Have a good one.
Deepsix
 

rgecy

Bronze Member
Jun 14, 2004
1,910
59
Beaufort, SC
Detector(s) used
Garrett Sea Hunter Mk II
I have a map showing the current fisher lease areas and all the coordinates. I will try to post it when I get home. Wreckdiver posted the coordinates and centerpoints last year or year before. You should be able to find it with a little searching.

Robert in SC
 

wreckdiver1715

Bronze Member
May 20, 2004
1,721
151
Satellite Beach
Detector(s) used
Minelab Excal 1000
Primary Interest:
All Treasure Hunting
You can find it in the Legal Issues Forum, in "Florida"

or I can just do a little cut and paste for ya...

Now these are only the Fisher leases, and there are others. However, I don't have them at this time. RioBravo said he may have the other current leases, so we might be able to entice him to add them for us.

BENT ANCHOR S32G 27.55.7N X 80.29.12W; East to 27.55.7N X 80.28.57W; South-southeast to 27.53.28N X 80.27.24W; West to 27.53.28N X 80.27.68W; then follow the mean low tide line to point of beginning.
CABIN WRECK S27 27.49.8N X 80.25.55W is the center point of a 3,000 yard radius excluding all land west of mean low tide line.
DOUGLAS BEACH S26 27.25.3N X 80.16.50W is the center point of a 3,000 yard radius excluding all land west of the mean low tide line.
POWER PLANT S25 27.21.2N X 80.13.65W is the center point of a 3,000 yard radius excluding all land west of the mean low tide line.
ANCHOR WRECK S23 27.48.2N X 80.24.70W is the center point of a 3,000 yard radius excluding all land west of the mean low tide line.
SPRING OF WHITBY S23 27.46.0N X 80.23.83W is the center point of a 3,000 yard radius excluding all land west of the mean low tide line.
RIO MAR S23 27.38.3N X 80.20.90W is the center point of a 3,000 yard radius excluding all land west of the mean low tide line.
SANDY POINT S23 27.35.8N X 80.19.65W is the center point of a 3,000 yard radius excluding all land west of the mean low tide line.
UNKNOWN S23 27.19.0N X 80.12.30W is the center point of a 3,000 yard radius excluding all land west of the mean low tide line.
CORRIGANS WRECK S25 27.46.2N X 80.22.67W is the center point of a 3,000 yard radius excluding all land west of the mean low tide line.
 

OP
OP
ScubaFinder

ScubaFinder

Bronze Member
Jul 11, 2006
2,220
528
Tampa, FL
Detector(s) used
AquaPulse AQ1B - AquaPulse DX-200 Magnetometer
Primary Interest:
Shipwrecks
Thanks gentlemen. I had Wreckdivers coordinates, those are the numbers i plugged into Google Earth...many of them state to draw a line up the mean low tide line, but those coords are in inland water ways and such. I had heard that Google Earth was less than accurate for pinpointing, I guess that rumor is true. I hate that, because being a computer nerd, I;ve been plotting every tidbit of info I can find into Google Earth, and it looks like most of my current data will not line up with the actual shore and reef lines at all :(

I've converted my KMD files to work with NASA WorldWind, and it looks to be much closer to accurate. I'm really just looking at known ballast piles, following debris trails, and trying to get a general "lay of the land" before I move out there early next year. If Robert posts his map this evening I think it will be good enough to get me started, thanks Robert. And thanks for the insights as well.

Jason
 

OP
OP
ScubaFinder

ScubaFinder

Bronze Member
Jul 11, 2006
2,220
528
Tampa, FL
Detector(s) used
AquaPulse AQ1B - AquaPulse DX-200 Magnetometer
Primary Interest:
Shipwrecks
Watch the tide tables, you will be able to get further out and into areas not normally available to be worked.

OK, this intrigues me to ask yet another question. When the tides are way minus, and you get some new area to be worked, what can you get away with as far as defacing the beach. I'm not talking about heavy equipment, but it seems that most targets would likely be on the hard bottom under the sand. I realize this is a bit silly, it would be really tough to get a hole dug quickly enough, and water would be backfilling it the whole time, but could you dig an 8 foot deep hole on the beach without getting harrassed by the law?

Jason
 

riobravo

Sr. Member
Apr 2, 2006
250
2
south texas to the east coast
hi jason,
i have charts showing the locations of most working sites, tried to find the link to a web site, ill keep looking i havent plotted all of the #s WD posted but a couple seem correct.
trying to post a pic of an older chart available from the state
 

Attachments

  • chart pic.jpg
    chart pic.jpg
    47.6 KB · Views: 2,449

Dirt Fishin Dale

Hero Member
Aug 23, 2006
799
17
Detector(s) used
Minelab E-Trac, Excal 1000, Binford 5000 super hunter
Jason
My 7 year old digs deep holes all the time. I will bring him out. :)
Looking foward to seeing that map of lease areas.
Dale
 

ScubaDude

Bronze Member
Oct 10, 2006
1,326
2
Coastal, NC
Detector(s) used
Garrett Infinium LS, Garret Seahunter MK II, Geometrics 882, Marine Sonic SS
Primary Interest:
All Treasure Hunting
Will these help??? Some are a rehash of the above, but this is some additional info.

ABBR SITE DATE LEASE AREA LATITUDE LONGITUDE
CAB CABIN 1715 8IR23/S27 27°49.800' 80°25.549'
ANC ANCHOR WRECK 1715 8IR46/S23 27°48.199' 80°24.699'
CAN CANNON WRECK 1715+ 8IR438/S23 *SEE BELOW *SEE BELOW
ROB ROBERT 1821 8IR47/S23 *SEE BELOW *SEE BELOW
SPR SPRING OF WHITBY 1824 8IR28/S23 27°45.999' 80°23.629'
GCB GREEN CABIN WRECK 1618 8IR22/S23 *SEE BELOW *SEE BELOW
COR CORRIGANS WRECK 1715 8IR19/S25 27°43.800' 80°22.799'
RIO RIO MAR WRECK 1715 8IR27/S23 27°36.300' 80°20.899'
SPT SANDY POINT WRECK 1715 8IR20/S23 27°35.599' 80°19.650'
DGB DOUGLAS BEACH 1715 8SL17/S26 27°25.299' 80°16.500'
POW POWER PLANT WRECK UNK S25 27°21.199' 80°13.650'
UNK UNKNOWN WRECK UNK S23 27°18.999' 80°12.300'

ABBR SITE DATE LEASE AREA
NORTH LATITUDE BOUNDARY SOUTH LATITUDE BOUNDARY CENTERPOINT
CAN CANNON WRECK 1715+ 8IR438/S23 27º48.202' 27º47.451' USE ANC
ROB ROBERT 1821 8IR47/S23 27º47.451' 27º46.708' USE ANC
GCB GREEN CABIN WRECK 1618 8IR22/S23 27º45.280' 27º44.247' USE COR



RECTANGULAR CONTRACT AREAS
ABBR SITE DATE LEASE AREA NORTH BOUNDARY SOUTH BOUNDARY
E89 EXPLORATION-89 UNK E89 28°02.209' X 80°31.899' 27°55.699' X 80°28.569'
S32 S32 1715 S32 27°55.699' X 80°28.569' 27°53.280' X 80°27.240'


Brad
 

Peg Leg

Bronze Member
May 29, 2006
1,520
5
Does anyone have any information concerning wrecks in the Gulf? I know that there is not much interest in this Gulf region but I sure am.
Thanks
Peg Leg
 

riobravo

Sr. Member
Apr 2, 2006
250
2
south texas to the east coast
hi peg,
i am awaiting some up dated info, there, to my knowledge, no active permits in the northwestern coast of florida, two companys that i know besides your self, have been investigating that area, with varying reports but no action started( permit apps, admiralty,...).
 

OP
OP
ScubaFinder

ScubaFinder

Bronze Member
Jul 11, 2006
2,220
528
Tampa, FL
Detector(s) used
AquaPulse AQ1B - AquaPulse DX-200 Magnetometer
Primary Interest:
Shipwrecks
Thanks Rio! I think I got what I needed from your pics. Google Earth is definitely "a little off" when it comes to GPS coordinates. I've got it pretty well lined out now though..thanks!

Jason
 

wreckdiver1715

Bronze Member
May 20, 2004
1,721
151
Satellite Beach
Detector(s) used
Minelab Excal 1000
Primary Interest:
All Treasure Hunting
Jason, I use software from Garmin "GPS MAPS OF THE WORLD", and can upload and download my GPS to my laptop with a USB cable. Additionally, most all of these coordinates provided by me are using the map datum WGS84.

Tom
 

OP
OP
ScubaFinder

ScubaFinder

Bronze Member
Jul 11, 2006
2,220
528
Tampa, FL
Detector(s) used
AquaPulse AQ1B - AquaPulse DX-200 Magnetometer
Primary Interest:
Shipwrecks
Thank you Tom! I'm wondering why I didn't think of this, but I went out to the truck and got my Garmin GPS out, punched in the numbers, and low and behold they were right where they should be :D I'm a little slow sometimes. I need to pick up the USB cable for mine, and will look into the software as well now...thanks!

Jason
 

Top Member Reactions

Users who are viewing this thread

Top