Help! my Minelab Sovereign Elite Digital ID is malfunctioning, (I think)

[dualshowman007]

Yikes!
So I go to turn on my Minelab and recalibtrate it on a quarter and the Digital ID meter shows "-1" and wont bounce around from target to target. Theres a knob on the back you use to fine tune the blasted thing, but it wont do anything now. If I turn it off and on again it will work fine for a sec or 2 and then go back to neg 1.
What the hell? Any Ideas? I cleaned and checked all the wires, dry lubed the sockets and looked for nicks and damage in the cables....so what now?
Thanks for any info!
DS007

 

Amazon Forum Fav 👍

A Handbook of Civil War Bullets and Cartridges - Grab it through Amazon!

[Mike(Mont)]

I'm no expert on this, but you may have some water damage on that control. When I did the 180 mod on my meter, there was some rust/corrosioin on it. The mod kit came with a new control. Probably only cost a few dollars for a new one. It is a little work to take the housing apart. You might find something at this site.
http://sovereignmods.da.ru/