Plugcut
Greenie
How to replace dfx pinpoint switch
Pinpoint switch
- Thread starter Plugcut
- Start date
Zincoln Miner
Hero Member
- Nov 14, 2003
- 567
- 360
- Detector(s) used
-
Minelab Vanquish 340, Tesoro Silver uMax, Compadre, and BH Tracker IV.
Ex: White's Spectrum XLT, Tesoro Cutlass II Umax, and that circa late 70's red handled junk from RadioShack that started it.
You can replace it with a simple on/off toggle switch. The momentary pull return, center off, and forward on I have seen out there (have to do a search "White's spare parts pinpoint switch").
I would do a simple on/off toggle. I imagine it's just two wires? One wire to center, then other wire to either one side, or just other leg.
Make sure battery is out of unit when working on it.
Here's a vid for a M6, but it was a connection that came loose.
You will need a micro toggle switch.
I would do a simple on/off toggle. I imagine it's just two wires? One wire to center, then other wire to either one side, or just other leg.
Make sure battery is out of unit when working on it.
Here's a vid for a M6, but it was a connection that came loose.
You will need a micro toggle switch.
Last edited:
Top Member Reactions
-
2574 -
1140 -
1051 -
910 -
889 -
833 -
815 -
704 -
641 -
527 -
496 -
495 -
486 -
464 -
462 -
O
442
-
422 -
396 -
377 -
364
