Tunstin ring

[jimzz977]

When looking for a ring that individual loss Cleaning his yard unknown would tungsten read at anybody help me out that

 

Amazon Forum Fav 👍

Diving for Pleasure and Treasure - Grab it through Amazon!

[toddbbq]

On the CTX the tungsten rings hit around 12-10 to 12-20 depending on size

 

[jimzz977]

So pretty close reading on a etrac, I was Afraid that I had discriminated it because I didn't find it

 

[cudamark]

So pretty close reading on a etrac, I was Afraid that I had discriminated it because I didn't find it

What discrimination are you running?

 

[jimzz977]

Factory pattern

 

[jimzz977]

This is the pattern I'm running

 

[toddbbq]

If I was looking for a ring on the surface I would run an open screen no discrimination just my opinion. The lost ring is probably in a trash pile or bagged.

 

[jimzz977]

Yuip lesson learned, I should've open screen I didn't think about until I left

 

[cudamark]

The factory coin/jewelry pattern should have no problem with finding a tungsten carbide ring. Assuming you properly gridded the area, either it wasn't lost there, got hauled off, found by someone, hidden where your detector can't reach, or it's masked by a nearby metal object. Check bushes and trees where it could get hung up. Also rain gutters depending on the circumstances of it being lost.

 

[Professor of Engineering]

IMHO: Run a wide open screen, turn down the sensitivity (should be surface or very very shallow) and grid the possible area with your largest coil.

Good Luck!

 

[Bart@Big Boys Hobbies]

IMHO: Run a wide open screen, turn down the sensitivity (should be surface or very very shallow) and grid the possible area with your largest coil.

Good Luck!

Good post!