teklord
Hero Member
- Sep 26, 2006
- 566
- 254
- Detector(s) used
- Excalibur 1000
- Primary Interest:
- Beach & Shallow Water Hunting
After being out of commission since January with a torn retina and the new full time job of " Mr. Mom " I finally got out for 2 whole hours on Saturday. My wife and I went out to Cocoa with the baby to visit a friend who has a condo on the beach. It felt great to get out if only for a short spin. Found 51 cents, 2 pull tabs, and a .925 spinner ring in the wet sand. The plastic shaft on my Excal where the coil attaches slipped out of the metal shaft. I think it is only glued in. I drilled a hole and added a bolt which should fix the problem permanently. The conditions were good and I wish I had time to go deep in the water, the waves were low and the tide was going out. Next time...
Tek
Tek
Attachments
Upvote
0