Interesting information

[mag]

Notice a very important attribute of my newly updated F75 LTD.

air test:

All prior owned F75 had basically the same ID number scheme.
Both clad and silver dimes read almost exactly the same
Both clad quarters and silver quarters did the same.

Now for the newly updated LTD.

Clad dime 70-71 silver dime 73-76

Clad quarter 80-81 silver quarter 84-87

The comparisons also go for the clad and silver halves.

This is a fantastic difference.

I might note in my test garden I have a very small copper rivet the size of a pencil eraser end, buried at 7" deep, (well it was 7" deep several years ago".
My machine, with stock 11" DD coil can easily detect and give a good audio report on this tiny target in boost mode, sensitivity 0, discrimination 0.
With DST enabled or not it still responds to this small target.

 

Amazon Forum Fav 👍

Cry Of The Eagle: History And Legends Of The Cherokee Indians And Their Buried Treasure - Grab it through Amazon!

[steve1357]

Thanks!

Difference between copper and zinc penny?

 

[vferrari]

Sensitivity 0, really!? (minimum setting is 1, max is 99. For an air test I would just reduce sensitivity low enough to eliminate any EMI related chatter, hopefully not having to go any lower than 60 to 65. Admittedly, sensitivity, regardless of setting, should not affect the vdi ID). Also, since you are running disc = 0, might want to see how the detector behaves for same targets in All Metal. Should get the same target ID's.