1970 COMPASS-
WHITES SILVER EAGLE-
WHITES DFX, 4X6DD COIL, 6X8DD COIL, 950 COIL, 10X12SEF COIL-
GARRETT PRO POINTER AT, GARRETT AT PRO , MINELAB EXPLORER SE with 8.5x12.5 Cors coil
Coil plug might not be installed all the way----and try this, here is what I run mine at, pro zero then, sens at 1 below the highest then, descrim at 25 then, iron audio off then , ground balance------always ground balance last
Coil plug might not be installed all the way----and try this, here is what I run mine at, pro zero then, sens at 1 below the highest then, descrim at 25 then, iron audio off then , ground balance------always ground balance last
I have found that sometimes the coil tightening ring will loosen up over time, perhaps due to the small clearance you have to get your fingers around the nut and provide a "good twist".
Ground balance by holding the ground balance button while hovering the coil and moving up and down to the ground. This is covered in the most basic of the at pro learning videos that Garrett produced and are available online. Check 'em out! The AT pro is a great machine and the better you ground balance the better the depth.
Too bad that quarter isn't just a couple years older like the date on the cent to the right. GOOD LUCK OUT THAR!