The ready to print image of my Bounty Hunter Tracker IV faceplate is available from bh-tracker-iv-custom-faceplate.png
Basic instructions
1. Save the image and print at full size using 600 dpi resolution
2. Cut out the knob/switch openings slightly smaller than the final size
3. Cut the cover from the page
4. Laminate using a laminating sheet, clear contact paper, or seal it using a fixative spray (art supply)
5. Cut out the openings, through the lamination
6. Remove both knobs from the Tracker IV
7. Remove the screws and slide the faceplate out of the control box an inch
8. Remove the nuts (note where they were removed as they vary in size)
9. Dry fit the cover on the faceplate - if needed enlarge any holes
10. For best results use Super 77 spray adhesive. However it may work fine without the glue
11. Place the cover back on and align it (let dry)
12. Reverse disassembly
Basic instructions
1. Save the image and print at full size using 600 dpi resolution
2. Cut out the knob/switch openings slightly smaller than the final size
3. Cut the cover from the page
4. Laminate using a laminating sheet, clear contact paper, or seal it using a fixative spray (art supply)
5. Cut out the openings, through the lamination
6. Remove both knobs from the Tracker IV
7. Remove the screws and slide the faceplate out of the control box an inch
8. Remove the nuts (note where they were removed as they vary in size)
9. Dry fit the cover on the faceplate - if needed enlarge any holes
10. For best results use Super 77 spray adhesive. However it may work fine without the glue
11. Place the cover back on and align it (let dry)
12. Reverse disassembly