AT Pro issue

[captbo]

Hello folks, I got out yesterday and got in a good hunt, I ran the ATP in Pro Zero with 35 points of disc. I toggled back and forth with the Iron Audio, abd the battery was at half, I notice with tones in the mid scale I was not getting a numeric value ,, Your thoughts please

 

Amazon Forum Fav 👍

Upgraded Night Vision Monocular Digital Infrared Monocular Telescope for 100% Darkness with 8X Zoom - Grab it through Amazon!

[austin_luker]

Target to deep for the Machine to get a VDI normally a good target dig all those!
Also Iron Audio will shift the mid tone to where you have discrimination set. I believe this is in the manual

 

[digger460]

I know that when there deep, it doesn't show up on the vdi. I've never noticed if it was just the mid-tones tho. Agree with austin, dig those.

 

[mooncusser]

captbo my A/T pro starts getting scratchy signals shortly after hitting half battery . so after scratching my >?< i changed the batteries and went back over my same spots and got solid tones . other then very old cans iam able to discern most targets.

 

[captbo]

thanks All this site is so full of great info ! it helps alot !

 

[mlutz]

That happened to me Saturday. Dang I wish I would have known that. I am still getting used to mine. I only have roughly 16 hours on it. Learning curve is not too bad though. I wonder how many belt buckles I went over..... Dhooo.... Slaps forehead.

 

[austin_luker]

Now not every signal no VDI is going to be a rock star, sometimes it's just deep iron but ya never know till you dig it and digging is free!

 

[Opie]

Sometimes the outside temp will effect things, mainly the battery out put, this can happen on both the hot end and the cold end. Good luck!!