Check Valves Done Dirt Cheap

[Jeff95531]

While looking to upgrade my shrimp gun, ran across this gem!

 

Amazon Forum Fav 👍

Cry Of The Eagle: History And Legends Of The Cherokee Indians And Their Buried Treasure - Grab it through Amazon!

[kcm]

I've seen a few of his videos before. Seems to have some good ones.

Thanks for posting this one, as sometimes I need a low-pressure check valve, but just not wanting to shell out $30 or more for one after driving 50 miles to town! ...Now I just gotta get some different sized balls to keep on hand.

 

[Jeff95531]

I'm thinking...superballs, bearings, marble boulders...

 

[winners58]

doesn't seem like materiel would go past the marble valve and get stuck.
a flapper valve would work better, could be made from some neoprene.
.
you could make a weighted one with a nut & bolt/washer in the middle. look at a foot valve to see how it works.

.

 

[Jeff95531]

Agreed winners58. The stopper (nail) could be recessed further away to allow for more volume/flow.

 

[winners58]

sounds like you got the creative juices flowing, try a bunch of different ways and make it your own...

 

[Jeff95531]

sounds like you got the creative juices flowing, try a bunch of different ways and make it your own...

Well it is raining and I'm too stuffed to move, so yeah.

 

[Jeff95531]

There is this too for less than $10. BUT, needs to be vertical and not horizontal.


http://www.homedepot.com/p/Everbilt...PIPHorizontal1_rr-_-205616001-_-205616014-_-N

 

[kcm]

There is this too for less than $10. BUT, needs to be vertical and not horizontal.


Everbilt 1.25 in. and 1.5 in. ABS Threaded ABS Sump Pump Check Valve-THD1021 - The Home Depot

It'll work as long as there's back pressure. Same thing with the DIY model. Only thing with a flapper-type check valve is, if you install horizontally, the flapper needs to have its hinge up top. That way gravity helps close the flap so that back pressure can make the seal.