I made one myself, and it worked pretty well in the wet sand, and dry sand, although i was told it looked very "dorky". I used a piece of 7 inch ABS pipe, and a wire mesh material available at home depot used for making plaster walls to make the scoop part. Cut the pipe at a 45-60 degree angle. Mount the mesh about 1 or 2 inches in the back end of the pipe, I tied mine in by drilling holes in the side of the pipe and using zip ties and then some epoxy. Make sure there are no sharp edges, no need to loose precious blood. You will also want to drill holes on the sides to help water and sand flow out. An optional kick plate can be added to the scoop area. You should have a decent sifter now. This part is fairly sturdy. The Hard part is getting it mounted on a handle. I had used a rake for a while, and held it on with zip ties, epoxy and duct tape, but am currently looking for something more stable. Its not exaltly deffinitive, but hope this helped some