mercury1
Bronze Member
Hi all, well the rain briefly let up and I got out in the yard to try out the 250. Actually when I got it on Thursday I did get out in the yard and discovered that all metal mode and steel toed boots don't mix. Was really tired and went right back inside so I don't count that as a hunt really. Anyway today I learned that I'm not yet ready for a real hunt as I had some problems understanding what the 250 was telling me. I practiced a little with a few coins I set out in the yard and I can find coins on the surface, no problem. I buried a few and had trouble at around 6". I couldn't get a signal that deep. Soil was topsoil and it was wet. Increased sensitivity to max and still nothing. Anyway, at lesser depths I felt pretty good about the signals I was getting and started hunting. Over the planted coins I got a beep with each swing but as I was searching, I would get a beep on the first pass but not on the back swing. Not sure how to interpret this. But eventually I got over several targets where I got a beep with each pass, back and forth and thought I had zeroed in on where to dig. This was in coin mode and the indicated depth was 6 to 8 inches but after removing some soil and checking with pin pointer I wasn't finding anything. Then, with the dirt out of the hole, and resweaping the area with the 250, I was no longer getting a signal. Not sure what to make of this. Switching to all metal mode, I got some shallow hits, indicating iron at 2 to 4 inches and using the pin pointer, was able to dig my first roofing nails. These nails were actually only an inch down, if that. Any advice or insight anyone could provide would be appreciated as I learn to use the 250.
Upvote
0