Grizzly Angle

[fowledup]

Can someone please tell me the factory grizzly angle on a Proline or Keene Highbanker. I'm making my fluidbed highbanker grizzly adjustable and need a middle position to start with for layout, thank you all!

 

Amazon Forum Fav 👍

Minelab PRO-FIND 35 Waterproof Pinpointer Metal Detector for Experts with Tone ID & Adjustable Sensitivity - Grab it through Amazon!

[QNCrazy]

I beleive it was between 21-25 degrees when I measured for mine.

 

[fowledup]

very nice, thank you I'll start at 23 and go from there

 

[QNCrazy]

Well you sure got me messed up. I thought I was going crazy. I looked a post under Sluicing and didn't see my response from this morning. At least I know i'm sane, at least by my standards.

 

[fowledup]

Sorry about that. I think I'm gonna go with an adjustable three sided basket. I have a heavy cast grill in it now but fear it will clear to fast. The goal is a good wash while retaining the self clearing. I plan on having a lot of adjustment to accomodate different material or poor water flow, just have to play with it a bit and see what that is gonna take. Also changing up the piping a bit since mine is quite a bit smaller than minny, going to 3/4" spray bars and 1/2" fluid bed tubes. Thanks again to all.

 

[2cmorau]

fowledup 3"proline highbanker i have, when it's set up to run material it's flat zip no degrees to mention, (no idea about keene) comes in handy when ya run across sticky clay