Seals and "o" rings for the Excalibur

[JoeSWFla]

Seals and "o" rings for the Excalibur

Has anyone on the forum found a source for the o-rings ,and especially the
cable seal under the flex nut on the front of the Excals when you hardwire
new coils .Would love to find a source for the original size and make of the
seals.Thanks and HH Joe

 

[OBN]

Re: Seals and "o" rings for the Excalibur

Smaller oring 2 per shaft- 1.5mm thick x 3mm (factory) or 3.5mm ID, 6mm OD

top Oring 1 per shaft- 1.5mm thick x 5mm ID, 8mm OD

the large end cap housing o ring- 3mm thick x 32mm ID, 38mm OD

McMaster-Carr

 

[JoeSWFla]

Re: Seals and "o" rings for the Excalibur

Thanks for the reply.You really did gut that machine.That covers all the o-rings.
Much appreciated.How about the cable seal/grommet.Did you ever find one to
replace that ,or did you just re-use the old one.Have wondered about what those
who hardwire in new coils use ,or just re-use.Would feel a lot better with a new one
than re-useing the old.Thanks again ,Joe