Treasure Cove 3020 Detector Use

[Lucky John]

I bought a Treasure Cove 3020 for my wife. And I have a MXT Pro. Does anyone have any good information on how the Disc, Notch and Disc notch are set up for normal use and when is the best use of each. She does fine in the All Metal but digs everything. Any help would be appreciated. The manual that comes with the MD was pub in 2008 and leaves much to be desired.

 

[Loco-Digger]

I think I'd run it in disc mode just to get the 3 tones. She can decide to dig low tones or not. I used a TC1023 when I started in May 2014. I liked the 3 tones much better than the all metal single tone. Mine had knobs and I used a nickle to set my disc. Depth can be determined by simply raising the coil as swinging over the target. You can gage the depth by target. Simple but effective machines. It should ID a quarter at 7" no problem and may get to 8" if you dig iffy's.

 

[Lucky John]

Thanks for taking the time to respond Loco-Digger. I started trying your advice right away and it gives us another approach to use, I like it. The tones work great after working with them. Thanks again.