What is the DEAL with nickel VDI numbers?!?!

[CoilToTheSoil]

11.7 and 17.6 both produce a wild variation of vdi and tone signals on us modern nickels. With 17.6khz if the coin is anything more than 1-2", tone fluctuations and wavering vdis run from 47-62 each sweep wavers. Tone matches the variance in vdi. Is it metal composition of the nickels which causes this or the fact that it's just a poor conductor?
It is the only us coin that produces this wide array of vdis aside from a rotten zincoln. Anyone else experience this?

 

Amazon Forum Fav 👍

Diving for Pleasure and Treasure - Grab it through Amazon!

[CoilToTheSoil]

I've dug over 50 nickels the past 2 hunts and this is a constant. Different sites, same results.

11.x + 17.xkhz
2 discrim
0-25 notch
2 reactivity
0 silencer
83 sens
11" coil

 

[scotty544]

I have had practically no time to swing the Deus this month, I am interested in all of the info and questions that are asked....wish I could help, but I am scheduled for knee replacement surgery in two weeks. ..going to beach hunt some this week then I will be done for the year sadly

 

[CoilToTheSoil]

Best wishes on the replacement brother and good luck out on that beach!

It's more of an oddity or annoyance, the vdi fluctuations. Due to the specific range the variations fall into (just below pull tab but above most foil), I can predict with fairly high accuracy when it is a nickel. But I'd like to heat what other users are seeing with their machines on buried nicks. I'll have to air test and see if I get similar results while air testing.

 

[CZconnoisseur]

Nickels are weird in any frequency on the Deus - I run 4kHz most of the time, and a clear, unobstructed, shallow nickel will read anywhere from 35-38 on my machine. If the same nickel happens to be 5-7" deep, I'll get a high-tone hit with variable VDI ranging from mid 30s to low 70s. If they are deeper than 7" I will get only a high tone, and switching to 8khz will sometimes help with stabilizing the VDI in the 40s or 50s.

Dug a Buffalo the other day at around 6" and it was a non-VDI high-toned hit. It had the round sound of a coin, but no readout - those are the signals I always jump on!

Only the nickels are slightly less sensitive while running 4kHz, using the other frequencies will "light up" deep nickels much better. 8 and 12 kHz are about neck-and-neck as far as nickel sensitivity, but for me these frequencies love deep iron a little too much....

 

[CoilToTheSoil]

Good deal, just the nature of the beast. Appreciate the confirmation!