AT Pro depth way off?

[WickedLife]

Just got the pro about a week ago. Was in a local park and found a few zinc pennies. They were at about 2 inches deep but the pro alerted 8-10 inches?? I scanned the whole again to make sure there was nothing under the penny. Was nothing. So I did a air test and when I pass a penny a inch away from the coil it bounces between 6-8 inches....what gives? Is it really that inaccurate?Sensitivity is one notch down from full, pro mode zero

 

Amazon Forum Fav 👍

Cry Of The Eagle: History And Legends Of The Cherokee Indians And Their Buried Treasure - Grab it through Amazon!

[Old Dude]

Are you getting the inaccuracy when you're pinpointing or when you first get the tone? Depth while pinpointing is the one to pay attention to. If it is off there, I would say contact the seller. He may take care of it,or tell you to call/email Garrett. They will help you definitely. Great customer relations dept.

 

[CincinnatiKid]

Many variables to be considered.
You are so new to the machine, your misinterpretation could be the problem?
Take a breath, Do Not send it for service and spend significant time with it.
The AT is a great machine.
GL
Peace ✌