BOUGHT A TESORO SAND SHARK

MackDog

Bronze Member
Nov 20, 2013
1,408
2,736
Spokane Wa
Detector(s) used
Garrett At Pro, 8 x11" and Nel Storm coils
Garrett Propointer er, Pro Pointer AT
White's V3i Standard, 10" DD, 13" Ultimate and 4 x6" sniper, 6 x10 coils, Drect 12 x 15 coil
Whites MX Sport With Detec
Primary Interest:
Metal Detecting

Terry Soloman

Gold Member
May 28, 2010
19,424
30,109
White Plains, New York
🥇 Banner finds
1
🏆 Honorable Mentions:
1
Detector(s) used
Nokta Makro Legend// Pulsedive// Minelab GPZ 7000// Vanquish 540// Minelab Pro Find 35// Dune Kraken Sandscoop// Grave Digger Tools Tombstone shovel & Sidekick digger// Bunk's Hermit Pick
Primary Interest:
Metal Detecting
FIRST, go to page 12 in the manual and MAKE SURE you have set your tone frequency to match YOUR hearing the best. Do you hear high or low tones better? Next, set your pulse width to about 3/4 power (2-230pm position). Turn your threshold up to where you can barely hear it above the waves and wind noise - like a mosquito hum, and use the machine in NORMAL mode.

DO NOT just walk up or down the beach in one direction or the other! Pick yourself a 50-yard long beachfront, and start gridding it. You start at the wet sand high mark and detect right into the water thigh-deep, move over a step and detect right back up to the high wet sand mark. Rinse and repeat until the whole 50-yards or 5-hours is done.

Slight “Positive” signals are also called “whisper” signals. This is a very soft or slight, almost unnoticeable, rise in the threshold signal. It will always be repeatable over the target – not random. If your threshold is set too high, or too low, you can miss them easily. If your threshold is not smooth you can miss these whisper signals easily. There can be a couple of reasons, including EMI, for an unstable threshold. The most common is too much pulse width. Sometimes you can max it out, sometimes you can only run it at the 12-1 o’clock position. It depends on the beach. If you want to make your machine more sensitive and cut down on interference, make sure you are not wrapping your coil wire close to the coil down on the lower plastic rod (see photo).

“Negative breaks,” are also referred to as whisper signals. This is when the threshold gets quieter, or goes away completely over the target. Again, negative breaks are always repeatable over a real target – not random. As you remove a little sand from over the target and re-sweep with your coil, the signal becomes a slight or stronger positive signal.
I use “Normal” mode, because it is easier for me to hear these positive and negative breaks in the threshold – that does not hold true for everyone. It takes time on the headphones to learn to recognize whisper signals, usually over 100-hours. Sometimes actually speeding up your swing back and forth helps to recognize these signals. The general rule however is always to SLOW down and pay attention.

I’m right-handed, so I swing the Sand Shark with my left arm. I mount the box up high and use the arm strap so that I let go of the detector and use my left hand to remove the target from the scoop. The arm strap keeps the detector right there attached to me, but gives me the ability to use both hands. Lastly, using your scoop effectively takes practice in the water. I put my toe just in back of the pinpointed target then place my scoop right in front of my toe for the recovery. This works well with practice. You’ll learn to time the waves. Hope this helps you, and feel free to PM me with any other questions or explanations. :skullflag:
 

Attachments

  • wrap.jpg
    wrap.jpg
    23.6 KB · Views: 46
Last edited:

DiggerinVA

Bronze Member
Sep 16, 2013
1,669
1,661
Shenandoah Valley, Virginia
Detector(s) used
GPX5000, AT Gold, AT Pro, Whites TDI, Bandido 2 umax, Tejon, Vaquero, Deus 2, ORX and Legend
Primary Interest:
All Treasure Hunting
Terry is much more knowledgeable than myself on the sand shark. But just to add some input that I found helpful when using one on the beach....once you hit at Target check it or scan it from all directions. If the tone ever breaks up it is more than likely an iron target. This helped me skip a lot of nails, wire and other junk items.
 

Terry Soloman

Gold Member
May 28, 2010
19,424
30,109
White Plains, New York
🥇 Banner finds
1
🏆 Honorable Mentions:
1
Detector(s) used
Nokta Makro Legend// Pulsedive// Minelab GPZ 7000// Vanquish 540// Minelab Pro Find 35// Dune Kraken Sandscoop// Grave Digger Tools Tombstone shovel & Sidekick digger// Bunk's Hermit Pick
Primary Interest:
Metal Detecting
Terry is much more knowledgeable than myself on the sand shark. But just to add some input that I found helpful when using one on the beach....once you hit at Target check it or scan it from all directions. If the tone ever breaks up it is more than likely an iron target. This helped me skip a lot of nails, wire and other junk items.

Very good advice DiggerinVA. There is a very slight chance of passing up a gold ring or earring though. I dug an antique mans 18k gold ring that had a broken band (worn away from being in the sand so long!), down about 13" in moderate black sand. The ring weighed in at 8-grams, so it was a honker. I almost walked away! Bobbypins give a double beep, unfortunately, so do gold hoop earrings. If you really want gold, Stay Calm and dig it all - at least until you have 150-hours on the headphones!
 

Attachments

  • intheh20.jpg
    intheh20.jpg
    46 KB · Views: 68
  • persistence.jpg
    persistence.jpg
    118.1 KB · Views: 68
  • stuff2.jpg
    stuff2.jpg
    93.6 KB · Views: 83

Top Member Reactions

Users who are viewing this thread

Latest Discussions

Top