granthansen
Bronze Member
- May 16, 2012
- 1,474
- 555
- Detector(s) used
- Minelab CTX 3030, Garrett Ace 350, Fisher CZ-21, Garrett Pro Pointer
- Primary Interest:
- All Treasure Hunting
Hey all... I got my Fisher CZ-21 from KellyCo and they did a fine job pre-assembling it. However, they didn't wind the coil cable around the shaft. Although the instruction manual says to finger tighten the cable to the coil, it's definitely on there a lot tighter than just done by hand. So, for you CZ-21 users... do you finger tighten? Or use a wrench and just gently tighten it off.
Hitting the beach Sunday. Can't wait!!
Hitting the beach Sunday. Can't wait!!
Amazon Forum Fav 👍
Upvote
0