I need a tall man shaft for my excalibur - any suggestions?

[time4me]

Does anyone know if there is an aftermarket lower rod for the excalibur that is longer than 24 inches? I'm 6'4" tall, and I'm finding that I need another 4 to 6 inches of reach.

(and my son Kenny had all sorts of laughs while I tried to come up with how to explain that my shaft was not long enough)

Thanks,

Jim

 

Amazon Forum Fav 👍

Treasure of Victoria Peak - Grab it through Amazon!

[GibH]

Funny, I was just looking at a golf ball retriever at WalMart thinking about it. They also had a 48" paint handle for a whopping $2.87. It looks to be about the right size, I think I will grab one to make a straight shaft for my PI Pro.

 

Amazon Forum Fav 👍

Diving for Pleasure and Treasure - Grab it through Amazon!

[Treasure_Hunter]

GIBH, where in Florida are you, are you close to Orlando?

 

[GibH]

I'm up near Pensacola T_H

 

[AUDuke]

You probably could have gotten a fiber glass one from Whites for ten bucks.

 

[Treasure_Hunter]

I'm up near Pensacola T_H

I sent you a IM.

 

[digum smacks]

made my own.its simple if your a handy person,painted her greeeen.all your paint handles and broom sticks and such "dont"work diameter of tubing is not the same tried 3 or 4 of them.you need 7/8in. dia all the paint handles and broom sticks are 3/4in or 1in..ace hardware some carries 7/8 .home depot and lowes "does not".if you want to go high tech use "titanium" tubing stronger and lighter,and cost alot more about $20 a foot or so.my rule of thumb standing straight up with coil should be almost tall as you

 

[Detector Wars]

You probably could have gotten a fiber glass one from Whites for ten bucks.

You can lead a horse to water...

 

[FISHEYE]

Go to a hobby shop like colonial photo and hobby,buy a carbon fiber tube.They sell them in 3 foot sections.The tubes are used for tail booms on r/c helicopters.They dont break or crush,you can cut it down to size with a hack saw or miter saw with a fine tooth blade.Plus the tube is super light weight.