pulltabfelix
Bronze Member
- Jan 29, 2018
- 1,011
- 1,631
- Detector(s) used
- Currently have CTX3030 and Vanquish 440.
- Primary Interest:
- Relic Hunting
Ok, I get that the 600 is for lower budgets than the 800. But these differences are they mainly software changes to artificially limit the 600? Or one or two less chips? Does anyone know where these differences occur, in hard ware or software?
I also get that you will have a certain percentages of 600 users buying 800s over time. So I am not arguing their decision but just trying to see where the cost are reduced on the 600.
I am thinking it is most all in the software and maybe a chip or two differences. This is way above my head guys. Just curious. We know they did save some money on water tight seals and coils ears and lower shaft quality.
And was the 600 and 800 introduction like other Minelab models in the past? (before my experience with Minelab).
I also get that you will have a certain percentages of 600 users buying 800s over time. So I am not arguing their decision but just trying to see where the cost are reduced on the 600.
I am thinking it is most all in the software and maybe a chip or two differences. This is way above my head guys. Just curious. We know they did save some money on water tight seals and coils ears and lower shaft quality.
And was the 600 and 800 introduction like other Minelab models in the past? (before my experience with Minelab).