Plugger carbon fiber rod on my excal 2

[Kwillie]

Just got my new plugger 45" balanced shaft for my Excalibur II. Looks and feels great can't wait to try it out.

 

Amazon Forum Fav 👍

Cry Of The Eagle: History And Legends Of The Cherokee Indians And Their Buried Treasure - Grab it through Amazon!

[beerguy]

Nice setup.

Do you plan on remote pinpoint?

 

[Kwillie]

Beerguy, I don't use it that much I run 1 descrimination, and 8 to 10 sensitivity.

 

[cudamark]

You realize that you're giving up a couple of inches in depth running it in disc rather than PP, right?

 

[Kwillie]

The air test does not indicate this. I'm sure discriminate uses some power to determine iron but with a full charge it's cracking on the beach. I have tried it and may do some more this winter now that I've cleaned house not much left.

 

[cudamark]

Air tests are not a real good indicator of depth ability on a Minelab. I find lots of signals in PP that are completely silent in Disc because the target is deeper than the discriminator circuit can detect it.

 

[fish1on]

Nice upgrade you have there. I was torn between the straight shaft and the Anderson over/under. Went with the Anderson but have yet to install it as it is a Xmas present.

 

[Kwillie]

Thank you.

 

[Kwillie]

I'll definitely give it a shot.

 

[ARC]

Kwillie... may I suggest you re-coil your wire.
Less wire low by the coil the better.

 

[ARC]

Leave slight slack so that coil can pivot without strain on wire in any way... zip just above rod joint area... then coil and zip near grip.

 

[islamoradamark]

your going to really like that plugger shaft been using mine over a year well balanced no drag cuts through the water

 

[Kwillie]

Thanks AARC recoiled and made sure there was plenty of slck at the coil.

 

[RustyGold]

You're going love the Excal attached to the plugger CF shaft. The balance is so good you'll be concentrating on the sounds as the coil floats over your targets. Best of luck!