billjustbill
Bronze Member
SE Depth Guage not working with 6" Excelerator coil?
I was out detecting this morning with the standard coil that comes with the SE model. It was a bit trashy, so I changed coils and went to the newer model of a 6" Excellerator coil....
Detecting around a lake's Marina beach, I kept hitting deep things that solidly rang out and the graph shows to be silver/aluminum can... What's odd about it is that when I would get tones that turned out to be quarters (9 total) the depth gauge would show the depth. When just as solidly hitting those deep "things", the depth gauge sat at the bottom of the scale. For awhile, I thought it was a defective coil, so I stopped and laid down one of the found quarters. The depth gauge would show it and I'd get the usual odd sounds telling me it was on the surface. But everytime I'd hit what might have been an aluminum can, the depth gauge kept registering the say way...just a tiny thread width line.
When I pin-pointed with the SE, the VCO would just barely be audible and be very weak compared to the solid tone I'd get when in the detecting mode...
What is it telling me and why does the graph and sound behave like I'd found a large silver coin but the depth graph basically just sits there?
Thanks,
Bill
I was out detecting this morning with the standard coil that comes with the SE model. It was a bit trashy, so I changed coils and went to the newer model of a 6" Excellerator coil....
Detecting around a lake's Marina beach, I kept hitting deep things that solidly rang out and the graph shows to be silver/aluminum can... What's odd about it is that when I would get tones that turned out to be quarters (9 total) the depth gauge would show the depth. When just as solidly hitting those deep "things", the depth gauge sat at the bottom of the scale. For awhile, I thought it was a defective coil, so I stopped and laid down one of the found quarters. The depth gauge would show it and I'd get the usual odd sounds telling me it was on the surface. But everytime I'd hit what might have been an aluminum can, the depth gauge kept registering the say way...just a tiny thread width line.
When I pin-pointed with the SE, the VCO would just barely be audible and be very weak compared to the solid tone I'd get when in the detecting mode...
What is it telling me and why does the graph and sound behave like I'd found a large silver coin but the depth graph basically just sits there?
Thanks,
Bill
