A Question?

[Davers]

I bought my XLT used & the edges of the loop 9inch, is about to wear through to it's innards so is there some kind of cheap fix? say a type of spray bed liner type of coating or some type of epoxy to increase it's useful (life) , I was thinking maybe JB weld or something that will harden & thicken the bottom edge & sides of the loop . Thanks for any help..Davers

 

Amazon Forum Fav 👍

Diving for Pleasure and Treasure - Grab it through Amazon!

[J.Cohoon04]

I would think some two-part epoxy would work. Someone feel free to correct me if I'm wrong though. Good luck!

 

[Sandman]

Most hunters use a coil cover but it is a chore to remove it to get out any black sand that gets inside the cover. Using an epoxy is the best way to protect the coil from wear.

 

[Davers]

Thanks guys I'm sure ill figure out something soon, yea I have a loop cover but the loop is worn to where it wont fit unless its glued or taped on. Thanks again..Davers

 

[pippinwhitepaws]

silicon....large bead, allow to dry, trim to fit.

 

[Joe hunter]

silicon....large bead, allow to dry, trim to fit.

i agree love silicon unless I'm painting.a polyurethane based caulk resists abrasion much better but takes a long time to dry