be accurate with the rods

[aarthrj3811]

For the new dowser I think it is important to be accurate with the rods. What the rods are made of and what kind of handles and how long they are is important. The most important thing to me is body position. You need to find a repeatable body position so that when you are on the target and the rods are crossed you can mark it.

When I noticed that I was digging some big holes to get a little gold I decided to work on the problem. The first thing I did was place a silver dollar on the floor. I put the heel of my boot on it and held my rods out and they only closed part way. I moved my arms back and forth and the rods opened and closed. I moved my hands in and out and they opened and closed.

So...I found a position for my arms with my hands 1 inch wider than the rod length. The position I chose was my arms at shoulder height and out as far as I could push them. I could repeat this position every time. I decided that I would use the front 1/2 inch of my left heel as my marking spot as I could reach it without hurting my back to much. I then started using a dime as my target.

The next step was to trim my rods so they were crossed and locked when my heel was on my spot and my arms and hands were in position. When on the target turn in different directions and adjust your feet as needed. Hope this helps some of you newbies.....

Art

A little over a year ago I awoke one morning and could not talk...After may test I was told I had a little stroke. Later after digging the third hole in a row with nothing in it I was very confused...So I started testing with my rods....I soon found that they were 15 foot off the target. After many months of testing I again have found a position and a set of rods that are crossing when my heel is on the coins.....My old rods were 13 7/8 inches long....My elbows are now tight againist my ribs and the rods are 9 1/4 inches long..Hope this helps someone that is having a problem....Art

 

Amazon Forum Fav 👍

Cry Of The Eagle: History And Legends Of The Cherokee Indians And Their Buried Treasure - Grab it through Amazon!

[aarthrj3811]

All minerals have what is referred to as a "HALO" or cone of energy that comes to the surface at a 45 degree angle from the target. To determine the depth of a target--------

1. Stand over your target with the L-rods crossed.
2. Slowly walk away from the target and the rods will open and point ahead.
3. Inch along until the rods form an inverted V with the tips about 1 !/2 inches apart and mark the spot.
4. Measure the distance back to your target. That's how deep the target is.
5. If you measured 1 foot the target is less than 1 foot deep.

One of the reasons that the length of the rods and body postion is so important is that you need to know the depth of the target.....The Halo of the object is what the one rod users lock onto....Art