Its out for delivery

liftloop

Silver Member
Joined
May 7, 2008
Messages
3,140
Reaction score
390
Golden Thread
0
Location
lakelinden mi
Detector(s) used
MXTdeepscan 8by14dd, bulls eye 2, 5900diprosl Maxima1500, Master Hunter cx plus Treasure Hound, surf
Primary Interest:
All Treasure Hunting
It's out for delivery

My tdi pro should be here to day, looked it up and it said
out for delivery
the brown truck stops shortly after 12:00 noon here every other time
with in an hour...a dream came true
of all thing to buy at this time....
it's not raining or snowing yet no wind the phone isn't ringing off the hook....
I think all do the dishes why'll I wait..


liftloop
 

It's here got to go
thanks you Bart at big boys hobbies...



liftloop
 

well I'm back and found a dime 1995 and a piece of copper and it loves iron
marked a bunch of targets the went over with mxt
and the two i dug were good the rest were iron
there should be an non motion on the thing
well in time all figure it out



liftloop
 

Congrats.
The "brown truck" has been good to me to. As well as Bart.
GL
Peace
 

Congrats on your purchase and New MD!!

:)
Be Well!
 

air test

hate to say
the 5900 with a 15 inch coil air test a foot or so over the tdi pro on a 8 inch aluminum target but that's an air test in the house.
but they were pretty close on a silver ring a bout 15 or so inches in the house. 5900 at pre set on the signal balance tdi pro max all metal ground balance off
need a bigger coil for the tdi pro the jimmy loop a mono I'm guessing. that 5900 is hard detector to beat. I need a test garden to settle it . the tdi smokes the mxt with the 950 eclipse in doors on the ring...all have to try the 15 inch max on the mxt all so...I have a big copper conglomerate in calumet it's about four feet deep. all go tomorrow and try the tdi pro on it. the 5900 has no problem with the 15' or the 950 coil you have to be right on top of it with the 950 deep scan. the mxt needs a 15' to find it..
found it with a box loop by Garret a few years back well that's it for now thanks for your replies...


liftloop
 

Top Member Reactions

Users who are viewing this thread

Back
Top Bottom