Mi 6 pinpointer volume too low?

[relicmeister]

I have an Mi4 and an Mi6 pinpointer and I like the way they work. I actually prefer to use the Mi6 with its speaker and not through my Orx WS4 headphones because I like to have the detector working to recheck the hole ( the coil shuts off while the pinpointer is in use).
Through the headphones the Mi6 is loud but the sound is muffled when used on speaker whereas the Mi4 is louder. Could this be a defect in the pinpointer speaker? Or something else? There’s no speaker opening that I’m aware of that could be clogged with dirt so I don’t see a cause for the low volume. Any ideas? Thanks

 

Amazon Forum Fav 👍

A Handbook of Civil War Bullets and Cartridges - Grab it through Amazon!

[relicmeister]

So it seems the difference in apparent volume difference between my Mi4 and Mi6 was due to the Mi6 vibrate being off. When I turned it to pitch plus vibrate it was now the same as the Mi4.
I did notice that the loudest sound comes through the back end of the unit and if you cover it up with your hand when you hold it the sound will be muffled. Therefore avoid holding the probe with the end covered by the palm of your hand.

 

[relicmeister]

Yup if you palm the end of the pp you will muffle the sound a lot so avoid holding that way

 

[Gare]

GOOD INFORMATION Relicmeister