Need some input

[jharhed]

Need some input MXT/M6 Covers

I have made a few of these to sell, I didnt want to dive into it without knowing what the need of this cover might be. Would this be of interest? Thanks, jhar

 

Amazon Forum Fav 👍

A Handbook of Civil War Bullets and Cartridges - Grab it through Amazon!

[Johnnoh]

I have a similar cover for my v3i. I usually do not leave home without it. What's yours made out of? It looks like a nice high quality job! How do those flaps work out? Do they interfere with your settings?

 

[jharhed]

Its 1000d water resistant cordura, flaps work fine no interferance. Was thinking abt making flaps totally removable, put on for nasty weather or whatever

 

[christo000]

In my opinión I honestly think they look good, nice meterial used,u use the machine you had made it for so there for you know what had to be covered up protected while still given urself Access to the controls needed for adjusting the machine. If I didnt have the silicone case on my deus,& didnt have a case on my Atpro u bet id get one from ya, had similar on my v3i & worked awesome kept it clean,scratch free. If I were you id make some pehaps throw a couple out forsale but do something to stand out alot are made black,camo,tan, so Why not do the black like uve done then mayb try & get a pink one for the women,mayb yellow or orange for people who If they put there machines down on the ground they wont blend in with the dirt & leaves. Just my opinions but they do look good sir

 

[jharhed]

thanks christo

 

[jharhed]

just sticking to black mostly, camo not too popular, have listed in classifieds, thanks jhar.