needed Garret headphone wiring diagaram

[B|lker]

Headphones received with my AT pro failed due to wire falling off their solder points.
Looks like they should be sealed from movement at the wire entrance to the headphones but their not.
Can any one take a picture of the insides of the earpiece so i can see what the wiring looks like on the volume control side of the head phones.
Thanks, in advance
b|lker

 

Amazon Forum Fav 👍

A History of Mining on the Kenai Peninsula, Alaska - Grab it through Amazon!

[Kodiak43351]

How long have you had the at pro Garrett customer service awesome but I'll see if I can take a pic.

 

[Kodiak43351]

How did you get yours apart don't want to bust mine looks like the ear piece in center spins out but not sure.

 

[missedshed]

I would also like to know how you got your headphones apart. I'm also having problems with the one side....wires inside are lose, sound comes and goes. Only way I can get sound to come back on is to wiggle the wires.

 

[B|lker]

The cushioned part comes off easily and stretches back on like a steering wheel cover.
The plate the speaker is mounted on will snap off straight up with your finger nail or very thin butter knife.
I plan on re-soldering new wire on everything and the sealing the connection were the wire enters the earpiece.
I purchase my AT Pro Last March.
Thanks everyone.
Bilker

 

[oakhunter27]

I would also like to know how you got your headphones apart. I'm also having problems with the one side....wires inside are lose, sound comes and goes. Only way I can get sound to come back on is to wiggle the wires.

Mine have done this since I have had them thought they were just junk

 

[Keppy]

Mine have done this since I have had them thought they were just junk

Could be you are right none of these detector companies and i mean all brands put out cheap head phones……With there detectors..