Nickles

[Terry228]

Whats up with these older nickles,cant seem to get a decent tone no matter what i do .Anybody got any ideas?Sure hate to miss these beautiful coins.100% nickle

 

Amazon Forum Fav 👍

How to Research for Treasure Hunting and Metal Detecting From Lead Generation to Vetting - Grab it through Amazon!

[SD51]

What detector are you using? Nickels are right next the a pulltab beavertail on mine...

 

[Terry228]

Xp deus 11 inch coil ws5 headphones with latest update

 

[SD51]

Have you planted some in a test garden and see how they read? I have to dig pulltabs to consistently get the nickels...

 

[Terry228]

No,just air test.Pretty well got the same results with at pro ,yet i probably found about 6 of these nickles with at pro.Both of these detectors failed at air test with a tone that I would walk over in the field.

 

[vferrari]

Air tests tell you nothing other than whether your detector is basically working. If you want real life tones and Target IDs, you need to bury your test targets.

How hard the detector hits on various types of targets is also dependent on what frequency your detector is operating at, the recovery speed setting (called reactivity on the Deus), your tone setup (3, 4, 5, pitch, full) etc.

Unlike your AT pro, many of these settings are highly variable on Deus, You need to either tell us the pre programmed mode you are using or specific settings to provide more help.

 

[SD51]

Air tests tell you nothing other than whether your detector is basically working. If you want real life tones and tdis, you need to bury your test targets.

How hard the detector hits on various types of targets is also dependent on what frequency your detector is operating at, the recovery speed setting (called reactivity on the Deus), your tone setup (3, 4, 5, pitch, full) etc.

Unlike your AT pro, many of these settings are highly variable on Deus, You need to either tell us the oreprogrammed mode you are using or specific settings to orovide more help.

Completely agree and plant some pieces of the old style of pulltabs as-well to see how your detector reacts.

 

[signal_line]

Yeah, nickels hit pretty good but the older ones bleed into the soil a bit and are not as sharp a signal and require a slower sweep speed to catch them. They read a little lower, too, like 62. Mess around with the frequencies, etc, to find the best sound. Probably want a somewhat higher freq. to get the best response. 18KHz I can usually tell if it is a nickel because it gives a little more oomph.

 

[vferrari]

Also, you need to recognize that depending on your ID Normalization setting (ID NORM ON/OFF in the Profile menu) TIDs will vary with operating frequency (ID NORM OFF) or will be fixed for all frequencies and normalized to the TID for that target as if operating at 18 khz. Target ID normalization is non-selectable and is always off if using an HF (white) coil.

 

[Rookster]

I like my Deus but my Fisher F75 is a nickel machine. I have found Nickels with the XP. They run in the 62-64 range.

 

[Terry228]

Going to maybe bury a couple of coins,thanks for the input

 

[vferrari]

I like my Deus but my Fisher F75 is a nickel machine. I have found Nickels with the XP. They run in the 62-64 range.

So is my Equinox. But I have found plenty of V's using my Deus/Orx, so it is no slouch. Likes silver war nickels too, but that is a whole different ballgame.

 

[secondstar]

Terry228, I have the X35 coil and hunt for coins using 25 kHz with ID Norm set to off. I’ve found that nickels really “pop” using 25 kHz and have a TID of 69 - 71. Check out this beauty that I found earlier this week.

 

[Terry228]

That is a nice one.I believe now with them in the ground it will make all the difference .I found them once i should be able to find them again.Ground was thawing nice here till yesterday,cooled off ,not to much diggin will be happening here for a few more days.

 

[CZKidd]

nickels

Found this V and buffalo. V had noTID, but the squeak was consistent. Finally got it to read at 62, Buffalo was a solid 63 before I dug it. V was down a good 12" and the Buff, about 4".

 

[E-Trac-Ohio]

I've found the Deus to be a great Nickel machine.

You must select "ID Norm" so you get the same target ID numbers in all the frequencies.
Then listen for solid sounding / clean breaking 63 to 64 range signals - Silver War Nickels will come in with a little higher target ID numbers - in 65 to 67 range.
You'll still dig some pull tabs and shotgun shell stamps now and then but after a while you'll usually be able to tell it's a Nickel before you dig it.

Good Hunting !

 

[srcdco]

Keep in mind that Terry is in Canada, so the older nickels he is talking about are 100% nickel (except the war years that were tombac and some in the 1950's that were steel), not a mixture of nickel and copper, like the US nickels. They will read different. Of course, the really old ones (pre-1922) are small silver coins and a lot more fun to find!

Scott

 

[Terry228]

That is correct 100% nickel,Love finding those little silver nickles,waiting for the 21 to pop out.