Jmaag76
Tenderfoot
- Joined
- Feb 18, 2015
- Messages
- 1
- Reaction score
- 0
- Golden Thread
- 0
- Location
- Zihuatanejo
- Detector(s) used
- Garrett 150
Tesoro Sand Shark
- Primary Interest:
- All Treasure Hunting
Hi,
I recently got a Tesoro Sand Shark and it just seems that it’s either uncalibrated or damaged. If the detector is very still it works as intended in VCO or Normal modes. But if I pick it up, it just goes crazy and beeps non stop even with very gentle moves.
I have followed the instructions on the manual but it seems that whatever I try it doesn’t stop going very loud and non stop beeping. Even with threshold down to min and Pulse width at preset or min, it goes off at any movement. I’ve tried indoors, outdoors away from any metal surfaces, even in water. I wear no jewellery either. I don’t see a reason for this erratic beeping. From my most recent tests I think it might be the coil. Is it a possibility, can I change it?
I know its not normal, so what could this be?
Thank you!
I recently got a Tesoro Sand Shark and it just seems that it’s either uncalibrated or damaged. If the detector is very still it works as intended in VCO or Normal modes. But if I pick it up, it just goes crazy and beeps non stop even with very gentle moves.
I have followed the instructions on the manual but it seems that whatever I try it doesn’t stop going very loud and non stop beeping. Even with threshold down to min and Pulse width at preset or min, it goes off at any movement. I’ve tried indoors, outdoors away from any metal surfaces, even in water. I wear no jewellery either. I don’t see a reason for this erratic beeping. From my most recent tests I think it might be the coil. Is it a possibility, can I change it?
I know its not normal, so what could this be?
Thank you!
Amazon Forum Fav 👍
Upvote
0