What are Mineralization Number when using a CTX 3030

[toolmanbutch]

Looking all over I can't find any real information on Sensitivity Panels Mineralization. Can anyone explain this to me? In Andy's book page 38 it says that the low numbers on the right hand side of the Sensitivity Panel equals higher mineralization. How low can the numbers be and how high can they be? I am confused. If I am in Auto or Manual what should I look for. I seem to average anywhere from an 11 to 17 on my panel.
Thanks,
Toolman Butch

 

Amazon Forum Fav 👍

Upgraded Night Vision Monocular Digital Infrared Monocular Telescope for 100% Darkness with 8X Zoom - Grab it through Amazon!

[Jason in Enid]

The suggested sensitivity number, below the sense level being used. Low is single digits, high would be near the max. A low suggested sens setting means there is a lot of mineral interference, a high number means there is very little.

Have you downloaded and read the user manual yet?

 

[toolmanbutch]

Yes I downloaded the Manual and I also purchased Andy's Book. I do not see any numbers listed. If Single Digits are Low what are High Numbers, what is Max? I am a little confused on this.
Thanks
Butch

 

[Jason in Enid]

I'm not trying to be an ass here, but the answer is on page 11 of the user manual.

 

[toolmanbutch]

Well Holy Crap. I am Blind in one eye and can't see out the other. Thanks Jason. No your not an Ass. You helped this new user a lot. Thank you.
Butch

I'm not trying to be an ass here, but the answer is on page 11 of the user manual.

 

[HollandsBrook]

I'm not trying to be an ass here, but the answer is on page 11 of the user manual.

I actually had the same question and am looking at page 11 in the manual. Are you referring to the illustration of the sensitivity panel where it shows a suggested level of 14? I'm looking at this manual:

StackPath