- Oct 27, 2016
- 218
- 195
- Detector(s) used
- Equinox 800, XP Deus 2, XP Deus, Tesoro Vaquero
- Primary Interest:
- Metal Detecting
Hi all,
I'm wanting to chest mount my CZ-3D (not neck mount, which would hurt my neck after 8 hours of detecting), to take some of the weight off of the handle when using the 10/5" coil. I've looked high and low for an option for the CZ-3D on the internet and can find nothing. Can anyone recommend a way to do this? I see there is a belt loop area underneath the control box - I'd rather not have this on my belt loop if at all possible.
Also - I contacted Anderson rods, in hopes of getting a new handle/lower rod for the CZ-3D but was told they do not support that model. Does anyone know of any other rod manufacturers that make lighter weight handle/rod assemblies for the CZ-3D?
Thanks in advance for any/all of your help!
I'm wanting to chest mount my CZ-3D (not neck mount, which would hurt my neck after 8 hours of detecting), to take some of the weight off of the handle when using the 10/5" coil. I've looked high and low for an option for the CZ-3D on the internet and can find nothing. Can anyone recommend a way to do this? I see there is a belt loop area underneath the control box - I'd rather not have this on my belt loop if at all possible.
Also - I contacted Anderson rods, in hopes of getting a new handle/lower rod for the CZ-3D but was told they do not support that model. Does anyone know of any other rod manufacturers that make lighter weight handle/rod assemblies for the CZ-3D?
Thanks in advance for any/all of your help!