Ground Balanceing tips for the X-terra 50

Oct 19, 2007
656
13
born in 3 sisters, tx. now living west of tilden
Detector(s) used
X-Terra70, X-Terra 50, Ace250, Ace150, GTI 1500,GTA 1000 Ultra, Tejon, Vaquero

Attachments

  • TH%20avatar_1198286554422922693.gif
    TH%20avatar_1198286554422922693.gif
    36.2 KB · Views: 187
  • TH%20avatar_1198286554422922693.gif
    TH%20avatar_1198286554422922693.gif
    36.2 KB · Views: 187

Sandman

Gold Member
Aug 6, 2005
13,398
3,992
In Michigan now.
Detector(s) used
Excal 1000, Excal II, Sovereign GT, CZ-20, Tiger Shark, Tejon, GTI 1500, Surfmaster Pulse, CZ6a, DFX, AT PRO, Fisher 1235, Surf PI Pro, 1280-X, many more because I enjoy learning them. New Garrett Ca
Primary Interest:
All Treasure Hunting
This is a quote from the field test by Andy.
While the factory ground balance setting provides stable performance in most areas, manually adjusting it as needed to compensate for severe ground conditions is easily accomplished though the touch-pads. An operational tip that can give a bit more performance is to find the optimal GB setting; i.e., no audio change as the coil is raised and lowered and then increase the setting by “1” – try it in "hot" ground and see the difference. The pinpoint circuit is another innovative addition developed by the Minelab team. When the pinpoint touchpad is depressed, the display changes to show a moving ring inside the one that appears when MENU is pressed that forms a complete circle when the coil is centered over the target. The audio response also aids in pinpointing by increasing in both volume and pitch as the coil approaches the target center. Combing the pinpoint circuitry with the depth indication provided through 5 arrows--each indicating approximately 2" in depth--the X-Terra allows for extremely accurate pinpointing and rapid target recovery which simply equals more "keepers" at the end of the day. The X-50 is powered by 4 AA batteries that fit into a compartment located in the housing itself. Alkaline cells will provide 20+ hours of operation. A ¼” headphone jack is located behind a protective rubber cover on the left side of the housing. Using headphones with a 90-degree plug is preferred over the straight-plug design based on the jack location.

Ground balancing must be done over a clean piece of ground. The whole field test may be seen at http://losttreasure.com/fieldtests/ArchiveView07.cfm?ID=LT20060136
 

Keppy

Gold Member
Nov 19, 2006
8,318
2,870
N.E. Ohio on lake Erie
Detector(s) used
** WHAT ONE I FEEL LIKE ON HUNTING DAY *****
Primary Interest:
Other
I got the dvd on the Xterra 30, 50, & 70 and the dvd explaines the ground balance .The X terras are easy to ground balance it has auto. ground balance that is easy to do and the manual ground balance is almost auto.to very easy.but then i am a mine lab user. Get the DVD you will not have a problem....==Jim==
 

Top Member Reactions

Users who are viewing this thread

Top