Miller table question: Pros and cons of using glass.

johnnysau

Full Member
Apr 23, 2012
233
117
Reno NV
Primary Interest:
All Treasure Hunting
Upvote 0
depends on type, tempered or anealed, tempered can not be cut and tends to warp in the heating process, anealed can be cut to any size, but will fracture depending on thickness DD or Double strenght is 1/8" common window pain but has a harder surface, then there is plate glass which is 1/4" thick and has a softer surface ?
 

G'morning Johnny, my friend, coffee? you are correct to a limited point. Remember the flow on a table needs to be 'directed' in order for a separation to take place. Also Glass has zero reserve from breakage, even from a dropped tool. If you are in an isolated area this would interrupt the recovery process until a replacement part can be brought in . The original tables used wood, which is generally quite efficient and easily replaceable.

One of the keys to effecient recovery is to be sure that all gold, especially the fines, is depressed below the surface of the liquid flow, I have found that floating a simple layer of plastic does this very nicely. No chemical expense is needed.

Don Jose de La Mancha.

p.s.Don't forget that glass is relatively soft and would be subject to rapid scouring which would negate what ever benefit that you would gain by it's original surface characteristic..
 

I would not recommend glass, for all the reasons that Don Jose de La Mancha stated above!

GG~
 

Top Member Reactions

Users who are viewing this thread

Back
Top