Anyone happen to know rotary switch pinout

[wraith1821]

So i want to add a waterproof switch outside of the housing of my excal while its open. Wondering if anyone knows the rotary switch pinout for the disc/pin knob. Honestly at this point im ok with jumpering full time disc mode just so its usable as the switch is goobered up. Dont need pinpoint in water anyways

 

[OBN]

Should not be hard to figure out since there are 5 connection points on the board, problem will be finding a IP68 pot to match.. I would think it would be easier just to replace the Pot with a new one..

 

[wraith1821]

I got it worked out. I just used a jumper wire to stay in disc mode for the time being. I still have the info you gave me last year just never got around to ordering. Family, life and work. We will be having a fun detecting day after all. Ill post pics tonight of the repair just in case anyone else has trouble.

 

[wraith1821]

On a side note ill never be making fun of my electronics classes in college again. Lol

 

[wraith1821]

And just rebuilt the pot. Tested good. I will most surely be eaten by a shark today as my luck is never this good. Haha

 

[cudamark]

I doubt you'll get eaten.....humans don't taste very good to them. Usually they take one bite and spit us out. That one bite can be a doozy though! Why not do a pin point conversion now that you have it apart? Make living with an Excal so much easier.

 

[wraith1821]

May do that. And not worried about sharks for real. Lol